Tapco Blend 6 Manual de usuario Pagina 1

owner’s manualby

1012. AUX RETURN INPUTSConnect the outputs of an external parallel effects device into these inputs.When connecting a mono device (just one cord), alw

11MASTER SECTIONBefore you read this section, have a read of the channel strip controls in the previous section.16. POWER LEDThis LED turns on when th

12OUTPUT CONNECTIONS24. MAIN OUTPUTS These 1/4" TRS jacks represent the end of the mixer chain, where your fully mixed stereo signal enters the r

13Appendix A: Service InformationRepairService for TAPCO mixers is available at our factory, located in sunny Woodinville, Washington. Service for TAP

14Appendix B: Connections XLR ConnectorsChannels 1 and 2 use 3-pin female XLR connectors on the MIC inputs. They are wired as follows, according to st

15Appendix C: Blend 6 Specifi cations Frequency ResponseMic Input to any Output (Trim at 0 dB): +0, –1 dB, 20 Hz to 20 kHz –3 dB

16AC Power RequirementsExternal Power Supply output: 9.0 VAC @ 1500 mA (2.5 mm AC coaxial power connection)External Power Supply AC input

17Block DiagramThis shows an outline of the strange goings on inside the mixer.PHANTOMMIC IN+48 VDCINST INLINE IN LEFT (MONO)LINE IN RIGHTAUX RETURN L

18Track SheetsUse these sheets to record some of your favorite settings.GAINU-22dB +25dB+3 +50MICGAINU-22dB +25dB+3 +50MICTAPCO Blend 6 NOTES1MONMON2F

19TAPCO LIMITED WARRANTYA. LOUD Technologies Inc. warrants all materials, workmanship and proper operation of this TAPCO product for a period of one

2SAFETY INSTRUCTIONS1. Read Instructions — All the safety and operation instructions should be read before this product is operated.2. Retain Inst

tapcogear.com

Part No. 0008813-90 Rev. A 1/04©2004 LOUD Technologies Inc. All Rights Reserved.3What me, read a manual?Before you begin, please make sure you read

4Getting StartedThe following steps will help you set up your mixer, and get the levels and adjustments just right.ZERO THE CONSOLE:1. Turn everythin

5A FEW PRECAUTIONS:• Never listen to loud music for prolonged periods. Please see the Safety Instructions on page 2 for information on hearing protect

6Here’s a quick glance at all the features packed into this mixer:2 mono mic/line channels, with:• Variable input trim (+3 to +50 dB for microphones,

7Hookup DiagramsSmall Club Gig 3/4BALBAL/UNBALUNBALLRLINE IN5/6BALBAL/UNBALUNBALLRLINE IN12(MONO) (MON O)MICINPUTINPUTMICINPUTINPUTINSTINPUTINPUTIN OU

8Blend 6 Features CHANNEL INPUTS1. MIC (MICROPHONE) INPUTSThe Blend 6 is equipped with two rugged, low-noise, phantom-powered microphone preamplifi ers

9CHANNEL CONTROLSChannel strips 1 and 2 allow adjustment of EQ, Pan and Level for mono signals. Channel strips 3/4, and 5/6 allow adjustment of stereo